11.5 Utility Call Key Setting
11.5.1 Utility call key setting function
The key position for calling the main menu of the utility can be specified.
For the key position, 1 point/2 points/no specification can be set for 4 corners on the screen.
(No specification can be set when GT Designer3 is used.)
When specifying 1 point, a setting to switch the screen to the utility by keeping pressing the key position is
available.
This prevents a switching to the utility by an unintentional operation.
The number of key positions that can be set differs depending on the GOT type.
Model name
GT1595
GT1585, GT157 , GT156 , GT155
Operation settings by GT Designer3 or GT Designer2
11.5.2 Utility call key display operation
Main menu
(
9.3 Utility Display)
Set the utility call key at [GOT set up] in [Environmental Setting] of GT Designer3 or
in [System Environment] of GT Designer2.
When change a part of the setting after downloading the project data, change the
setting by [Display] screen of the GOT.
• GT Designer3 Version1 Screen Design Manual (Fundamentals)
(4.9 GOT Display and Operation Setting)
• GT Designer2 Version
(3.8 Setting of the GOT display and operation (GOT setup))
GOT setup
Touch
[GOT setup]
Menu call key
The number of settable key positions
1 point, 0 point (no specification)
1 point, 2 points, 0 point (no specification)
Screen Design Manual
Operation settings
Touch
[Operation]
11.5 Utility Call Key Setting
11.5.1 Utility call key setting function
Touch
[Utility call key]
Touch buttons to set
for the menu call key
11
- 20
9
10
11
12
13
14
15
16