6
Tighten the extend interface relay board installed by the step
range (0.36 to 0.48N·m). (2 places)
7
When installing an extension unit on the unit, refer to the following.
When not installing an extension unit on the outer layer, cover the top of mounting screws (4
places) with accessory stickers in order to avoid receiving static electricity.
Keep the connector cover fixed.
Keep the sticker stuck as it is.
8
8.4 Video/RGB Unit
- 24
8.4.2 Installing procedure
Removing the video/RGB unit
Before removing the unit, unscrew the extend interface relay board fixing screws.
(
)
above
8.1.3 Installing multiple extension units in layers
within the specified torque