Mitsubishi GOT1000 GT15 User Manual page 541

Error
Error message
code
Too high frequency of
317 data collection.
Review conditions.
Specified object does not
320
exist or out of range.
Dedicated device is out of
322 range. Confirm device
range.
Insufficient memory media
330 capacity. Confirm M-card
capacity.
Memory card not installed
331
or M-CARD switched OFF
Memory media is not
332
formatted.
Unable to overwrite.
333 Memory card is write-
protected.
Memory media error.
334
Replace memory media.
Memory card battery
335 voltage low. Replace
battery.
File output failed. Confirm
337
output file path.
Printer error or power
340
failure
Action
Data of an object, to which [Collect data only when trigger
conditions are satisfied] is set, are collected too frequently, or
the number of objects has exceeded the number of objects
collectable simultaneously.
1. Set a longer cycle for trigger occurrence to each object.
2. Make the settings so that 257 or more display triggers of
objects, to which [Collect data only when trigger
conditions are satisfied] is set, do not occur
simultaneously.
The part file does not exist.
Create the part file and download to GOT.
The monitored device No. is out of the permissible area of the
targeted PLC CPU.
Set the device within the range that can be monitored by the
monitored PLC CPU and parameter settings.
Available memory of the memory card is insufficient.Confirm
the available memory of the memory card.
The available memory can be confirmed by system
information screen, which is described in GT Designer3
Version1 Screen Design Manual (Fundamentals) or GT
Designer2 Version Screen Design Manual.
The memory card is not installed or in the drive access switch
is OFF in drive.
1. Install the memory card in the specified drive.
2. Turn ON the access switch.
Memory card is not formatted or formatted incorrectly.
Format the memory card.
Memory card is write-protected.
Cancel the write-protection of memory card.
Memory card is faulty.
Replace the memory card.
The battery voltage of the memory card is low.
Replace the battery of the memory card.
Either of the following folder or file with the name same as the
file to be created exists in the storage destination memory
card.
Folder storing data
Write-protect file
Delete the above folder or file, or change the name of the file
to be created.
Printer is faulty or the printer power supply has not been
turned on.
1. Confirm the printer.
2. Turn on the power supply of the printer.
20.3 ERROR MESSAGE AND SYSTEM ALARM
20.3.2 List of Error Message/System Alarm
17
Channel
No.
storage
18
19
20
20
- 21