Noise Filter (Power Supply Line Filter) - Mitsubishi GOT1000 GT15 User Manual

Graphic operation terminal

Hide thumbs Also See for GOT1000 GT15:

Table of Contents

Noise filter (power supply line filter)

The noise filter (power supply line filter) is a device effective to reduce conducted noise. Except some

models, installation of a noise filter onto the power supply lines is not necessary. However conducted noise

can be reduced if it is installed. (The noise filter is generally effective for reducing conducted noise in the

band of 10MHz or less.) Usage of the following filters is recommended.

Manufacturer

Rated current

Rated voltage

The precautions required when installing a noise filter are described below.

(1) Do not install the input and output cables of the noise filter together to prevent the output side noise

will be inducted into the input side cable where noise has been eliminated by the noise filer.

(2) Connect the noise filter's ground terminal to the control panel with the shortest cable as possible

(approx. 10cm (3.94 in.) or less).

(power supply side)

(device side)

(a) Installing the input and

output cables together will

cause noise induction.

(power supply side)

(b) Separate the input cable

from the output cable.

5.1 Requirements to Meet EMC Directive

5.1.3 Noise filter (power supply line filter)

(device side)

Got 1000 Gt15