Table of Contents
Advertisement
(1) When using GT1595-X
For the key position, 1 point only can be specified.
(2) Specifying another key position when two
Change either key position from
You cannot select three
Example: Changing the 2 points of the upper left and right corners to those of the
upper left and lower left corners.
Change
at the upper
right corner to
.
(3) When the utility call key is not specified
The followings are the method for displaying the utility without using the utility call
key.
(a) Changing the project data in GT Designer3
1. Read the project data in GT Designer3.
2. Set either of the followings in GT Designer3.
• Set the utility call key in the [Display/Operation] tab of the
[Environmental Setting] dialog box.
• Set a special function switch to display the utility at the user-created
screen.
3. Write the project data whose setting is changed to the GOT.
(b) Operating the forced start-up of the utility with the GOT
The operation differs depending on the GOT to be used.
GOT
GT1595-X
Other than
above
When restricting the display of the utility, set a password in GT Designer3.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
(4.7 Security Setting)
to
at the same time.
Change
at the lower
left corner to
.
Forced start-up of the utility
After powering on the GOT, press the S.MODE switch during
[Booting] displayed on the upper left in the screen.
Power on the GOT with touching the upper left of the GOT screen.
11.5 Utility Call Key Setting
11.5.3 Utility call key setting operation
have been already set
before specifying.
9
10
11
12
13
14
15
16
11
- 22
Advertisement
Table of Contents
Troubleshooting
