Table of Contents
Advertisement
20.3.2 List of Error Message/System Alarm
The system alarm detected with GOT is shown below.
Error
code
Set monitor points too
303
large. Decrease setting
points.
Set trigger points too
304
large. Decrease setting
points.
No project data.
306
Download screen data.
307 Monitor device not set
No comment data.
308
Download comment.
Device reading error.
309
Correct device.
Project data does not
310
exist or out of range.
No. of alarm has
311
exceeded upper limit.
Delete restored alarm.
No. of sampling has
312
exceeded upper limit.
Delete collected data.
Device writing error.
315
Correct device.
Cannot display or input
316
operation value. Review
expression.
20
20.3 ERROR MESSAGE AND SYSTEM ALARM
- 20
20.3.2 List of Error Message/System Alarm
Error message
Decrease the number of objects from the displayed screen.
For the number of maximum objects for 1 screen, refer to the
following.
The number of objects using Sampling/Cycle during ON/
Cycle during OFF exceeds 100.
Decrease the number of objects.
The project data is not downloaded or the screen data is not
sufficient.
Download the project data or screen data.
The monitor device of the object is not set.
Set the monitor device of the object.
The comment file does not exist.
Create the comment file and download to GOT.
The error occurred when reading a continuous device.
Correct the device.
1. Specified base screen / window screen does not exist in
2. Specified base screen / window screen is out of the
The number of alarm histories that can be observed by the
alarm history display function has exceeded the maximum
points.
Delete the restored history to decrease the number of alarm
histories.
The collection frequency exceeded the upper limit when
"Store Memory" and "Accumulate/Average" were set in the
scatter graph.
1. Approve "Clear trigger" setup in the scatter graph.
2. Set the "Operation at frequency over time" to "Initialize
Error occurred while writing in the device.
Correct the device.
In indirect specification of comment/parts number, the data
operation result exceeded the range in which device type can
be expressed.
Review the data operational expression, in order not
exceeding the range in which the device type can be
expressed.
Action
• GT Designer3 Version1 Screen Design Manual
(Fundamentals)
• GT Designer2 Version
the project data.
permissible area. Specify the existing base screen /
window screen.
and Continue" in scatter graph.
Screen Design Manual
Channel
No.
storage
Advertisement
Table of Contents
Troubleshooting
