30 Aprii, '89
DF Removal
10.
1.
Remove the DF front cover
screws).
2.
Remove the copier upper rear cover (2 screws).
3.
Lower the DF main board assembly [C] (2 screws) and disconnect the
two fiber optic cables [D].
Remove the feed-in unit ground wire [E] (1 screw).
4.
CAUTION: In the next step, do not damage the fiber optic cables.
Remove the feed-in unit [F] (3 screws and 3 connectors).
5.
Disconnect the transport unit ground wire [G] (1 screw).
6.
Remove the exposure glass.
7.
Section 3.) (This makes it easier to untangle the connectors. )
8. Remove the transport unit [H] (3 screws and 2 connectors),
[B]
/
[A] (2 screws) and the DF rear cover [B] (3
(Refer to "Exposure Glass Removal" in
7-50