Installation Procedure; First Sorter/Staplerpreparation - Ricoh FT7770 Service Manual

1 August 1990

5.2 INSTALLATION PROCEDURE

CAUTION: Turn off the copier main switch before starting installation.
5.2.1 First Sorter/Stapler Preparation
If the Sorter/Stapler has been installed, start at step #1 on this page. If the
Sorter/Stapler has not been installed, skip steps #1 - 4, and go next page.
1. Remove the screws securing the fixing bracket [A] (4 screws).
2. Screw the leveling stands [B] up until the sorter/stapler rests on the
casters, and remove the stand shoes [C].
3. Open the copier top unit and remove the sorter/stapler. Be careful not to
damage the fiber optics cable [D].
4. Disconnect the fiber optics cable from the copier's connector [E].
14-6