Table of Contents
Advertisement
30 April, '89
2. Installation Procedure
CAUTION: Turn off the copier main switch.
1.
Remove all external strips of tape [A], styrofoam block and cut the two
cable ties [B] securing the roller panel.
2.
Remove the bin number bracket [C] (2 screws and 2 ground screws) and the
distribution unit support bracket [D] (7 screws).
3.
Install the bins as follows:
a) Set the two bin trays [E] that do not have antistatic brushes at the 10th
and 20th bin positions.
b) Set the proof tray [F] in the top position.
c) Set the bin trays with antistatic brushes [G] in the other positions.
4.
Reinstall the bin number bracket.
5.
Reinstall the distribution unit support bracket.
6.
Install the manual feed table [H] (2 screws).
9-22
Advertisement
Chapters
Table of Contents
