Ricoh FT7770 Service Manual page 598

1 August 1990
16. Slide the connector unit [A] into the first sorter/stapler. While sliding it in,
slightly lift the paper entrance section of the connector unit so that the
bracket [B] meets the docking pin [C].
CAUTION: Be careful not to damage the side plate HP sensor.
17. Fix the connector unit with the sorter/stapler at the front left [D], front
middle [E], and rear middle [F] of the unit (3 screws).
18. Tighten the screws while pressing the locking bracket [G] to the left.
19. Install the lowest two bins, front bin bracket and rear bin bracket.
19'. Remove the Gate spring from the TOP of the 21st bin gate (very bottom)
and re-attach the spring to the BOTTOM spring hole. (This is to keep
the 21st gate open at all times.)
14-10