Pre-Cleaning Corona Wire Replacement - Ricoh FT7770 Service Manual

2. Pre-cleaning Corona Wire Replacement

1. Remove the front and rear endblock covers [A,B]. (Be careful not to
break off the side hooks.)
2. Unhook the old wire [C] from the tension spring [D] and remove.
3. Clean the front and rear endblocks and the corona casing.
4. Hook the small eyelet [E] of a new wire to the tension spring.
5. Hook the large eyelet [F] of the new wire to the anchor post on the
front endblock cover, then set it on the front endblock. (Ensure that
the wire is in the positioning grooves.)
6. Reassemble.
5-37
30
April, '89