Ricoh FT7770 Service Manual page 436

30
April, '89
9.
Loosen the Allen screw of the collar [A]
entrance roller shaft [B].
10. Remove the lower belt tension roller shaft
[C] (2 E-rings).
11. Remove the inside idle roller shaft [D].
12. Remove the lower belt drive gear [E] (1 E-ring).
13. Open the roller panel [F] of the upper distribution unit.
14.
Loosen the Allen screw of the collar [G] and, while holding up the turn
gate [H], remove the lower belt drive roller shaft [I].
NOTE: The lower belt drive roller shaft [H] has a pin [J] on the end of the shaft. Align
the pin with the
15. Replace the lower transport belts.
16. Reassemble.
in the frame of the sorter.
cut-out
9-32
and remove the lower belt
along with the pressure arms