Table of Contents
Advertisement
30 April, '89
- Sorter Connector Unit Preparation -
1.
Remove all the external strips of [A] and the two polystyrene covers
[B] .
2.
Remove the upper [C] and lower [D] rear covers (5 screws).
- Docking (Sorter connector unit & First sorter) -
1.
Loosen the screw [E] securing the locking bracket then, dock the sorter
connector unit with the first sorter (2 screws).
docking pin [F] is seated firmly in the notch on the sorter connector
unit. (Do not bend the upper guide plate.) Secure the two screws [G].
2.
Tighten the screws while pressing the locking bracket [H] to the left.
3.
Remove the cover plate [I] (2 screws) from the first sorter.
Pass the interface harness [J] from the sorter connector unit through
4.
the opening [K], and couple it to CN115 (20P) [L] on the first sorter
main PCB.
Then, install the harness bracket [M] (2 screws.)
10-10
Make sure that the
Advertisement
Chapters
Table of Contents
