30
April, '89
6. Application Switch
When the original application switch is turned on (Thick), CN104-1 receives
a LOW signal and the DF CPU selects the original reverse mode.
mode, the belt motor reverses to align the trailing edge of the original
with the right scale.
bent since they do not have great stiffness. Therefore, when the applica-
tion switch is turned off (CN104-1 becomes HIGH), the DF CPU selects the
non-reverse mode.
the correct position.
Thin originals (tracing paper etc.), however, may be
In this mode the original is fed in and stopped just at
7-30
In this