Ricoh FT7770 Service Manual page 267

30
April, '89
ADJUSTMENT STANDARD: 2.0 mm
- Adjustment -
If the inverter roller clutch hub [A] or clutch
perform the following adjustment:
8. Loosen the two Allen screws fixing the
shaft.
9. Insert a 0.2 mm thickness gauge [C] at the position shown. While hold-
ing the clutch assembly against the gauge, rotate the clutch drive gear
clockwise until stopper [D] of the clutch sleeve contacts the clutch
s o l e n o i d a c t u a t o r [ E ] .
10. Position the eccentric pin [F] so
tion.
Tighten the clutch hub (2
11. Reassemble and check operation.
shaft [B] has been replaced,
clutch hub and the clutch
that it aligns with the 9 o'clock posi-
Allen screws).
5-54