Vrf (Netflow-Lite Exporter Submode) - Cisco Catalyst 4500 Series Command Reference Manual

vrf (netflow-lite exporter submode)

vrf (netflow-lite exporter submode)
NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To specify a VRF label for the NetFlow-lite collector, use the vrf command. To delete a VRF label, use
the no form of this command.
Syntax Description
vrf-label
Defaults global vrf
Command Modes netflow-lite exporter submode
Command History Release
15.0(2)SG
Usage Guidelines By default when no vrf label is specified the global vrf is used for routing. The vrf label is ignored if the
collector's address is IPv6. Default global routing table is used to route the IPv6 export packets to the
collector.
Support for VRF with IPv6 will be provided in a later release.
Note
Examples
This example shows how to specify a VRF label for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-1128
vrf source-address
no vrf source-address
Specifies a VRF label for the NetFlow-lite collector.
Modification
Support for this command was introduced on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01