Avaya DEFINITY Server CSI Maintenance Manual page 1738

Maintenance Objects
Processor circuit pack replacement
When replacing a processor circuit pack, follow the procedures in
Standard Reliability:
— Begin the procedure with Step #3.
High and Critical Reliability:
— Follow the procedure through once. Work on the standby side first,
NOTE:
Translations loaded from a duplicated system flash card into a simplex
system, even where one of the translation IDs on the flash card corresponds
to the ID on the processor, results in translation ID mismatch.
Table 516. Processor circuit pack replacement procedure
Step Description
1. Suppress alarms
2. Busyout the standby
PPN
3. Remove the old
processor circuit pack
4. Replace the processor
5. System detects ID
mismatch
6. Release standby PPN
1738
Issue 5 October 2002
then on the active side.
Command
change
system-parameters
maintenance
busyout
standby-spe
release standby-spe
Table 516:
Procedure
Change the Alarm
Origination to OSS
Numbers field to neither
(Screen 87 on page 1739).
Press Enter to effect the
changes.
Unlatch the old processor
circuit pack and slide it out of its
slot (no power-down required).
Slide the replacement
processor circuit pack in the
slot and latch securely.
The system detects the
translation ID mismatch,
displays the warning message,
and generates a MAJOR alarm
(TRANS-ID).
Releases the standby PPN.
Continued on next page