Avaya Communication Manager Administrator's Manual page 1437

Access Code
This field appears when a wireless terminal model number is selected in the Type field. The
Access Code is a temporary, shorter version of the complete User Authentication Key (UAK)
required by the system when the terminal is first put into service. It is then used to automatically
generate a unique UAK for that wireless terminal over-the-air.
Valid entries
5-digit decimal
number
Active Station Ringing
Defines how call rings to the telephone when it is off-hook. This field does not affect how calls
ring at this telephone when the telephone is on-hook.
Valid entries
continuous
single
if-busy-single
silent
Adjunct Supervision
Adjunct Supervision appears when the Type field is 500, 2500, k2500, 8110, ops, ds1fd,
ds1sa, VRU, VRUFD, or VRUSA.
Valid entries
y
n
Usage
Enter the 5-digit access code to place the wireless terminal into service.
Default is blank.
Usage
Enter continuous to cause all calls to this telephone to ring continuously.
Enter single to cause calls to this telephone to receive one ring cycle and
then ring silently.
Enter if-busy-single to cause calls to this telephone to ring continuously
when the telephone is off-hook and idle and calls to this telephone to
receive one ring cycle and then ring silently when the telephone is
off-hook and active.
Enter silent to cause all calls to this station to just ring silently.
Usage
Enter y if an analog disconnect signal is sent automatically to the port
after a call terminates. Analog devices (such as answering machines and
speakerphones) use this signal to turn the devices off after a call
terminates.
Set this field to n so hunt group agents are alerted to incoming calls. In a
hunt group environment, the disconnect signal blocks the reception of zip
tone and incoming call notification by an auto-answer station when a call
is queued for the station.
Station
Issue 2.1 May 2006 1437