Avaya Communication Manager Administrator's Manual page 1418

Screen Reference
Tip:
For SIP Enablement Services (SES) signaling groups, if either the node name or
Tip:
port differs for each group, you have different SES signaling connections, and
you should administer a maximum of 10 using TLS. If you administer more than
10 TLS signaling connections, and they are all in use at the same time, the
results can be unpredictable. Note that if the node names and ports match, you
can administer as many identical SES signaling groups using TLS as desired.
Group Number
A display-only field identifying the signaling group.
Group Type
This field describes the type of protocol to be used with the signaling group.
Valid entries
atm
h.323
isdn-pri
sip
H.235 Annex H Required
Appears only for signaling group type h.323.
Valid entries
y/n
Idle Code
Appears when the Group Type field is atm. This entry sets the signal sent out over idle DS0
channels. The string must be compatible with the protocol used by the far-end switch/server.
Valid entries
0, 1
1418 Administrator Guide for Avaya Communication Manager
Usage
Use for Asynchronous Transfer Mode signaling trunks
Use for h.323 protocol or when using SBS signaling trunks.
Integrated Service Digital Network Primary Rate Interface
For SIP Enablement Services (SES) on the Avaya S8300, S8400, S8500,
and S8700.
Usage
Enter y to indicate that the CM server requires the use of H.235 amendment
1 with annex H protocol for authentication during registration.
Usage
Enter an 8-digit string.