Avaya Communication Manager Administrator's Manual page 1329

Valid entries
resend-digit
setup-sppath
Group B
Valid entries
busy
congestion
free
mct
tariff-free
toll-busy
intercept
Definitions of Group I, II, A, and B signals
Group I signals
Group I signals are a set of forward signals generated by the originating media server or switch.
ani-avail
Used in Hungary. If this signal is defined and ANI is requested on outgoing R2-MFC calls, ANI is
sent to the CO before ANI caller digits are sent. This signal is sent after the ANI caller category
signal.
ani-not-avail
Used on DOD calls in Brazil and Columbia. Communication Manager sends this signal to the
CO when it receives an ANI request and the caller's number is not available.
digits 1 to 10
The signals from group I.1 to I.10 are reserved for address digits 0 to 9.
Usage
Usage
Message codes between 1 and 15 display. Assign a meaning to each
code. See Definitions of Group I, II, A, and B signals
signal type.
Multifrequency-Signaling-Related Parameters
Issue 2.1 May 2006
2 of 2
on page 1329 for
1329