SmartWare Software Configuration Guide
Call outbound face
The call outbound face is used to configure call properties for outgoing calls.
Mode: Identity
Step
1
[node](identity)[name]# [no] call out-
bound
Mode: Call outbound
Step
1
[node](callout)[name]# [no] use profile
(sip|tone-set|voip) <profile>
Mode: Call outbound
Step
1
[node](callout)[name]# [no] preferred-
transport-protocol (tcp|udp)
Mode: Call outbound
Step
1
[node](callout)[name]# [no] traffic-class
<traffic-class>
Mode: Call outbound
Step
1
[node](callout)#proxy <host> [<port>]
[strict-route]
or
[node](callout)#proxy <index> <host>
[<port>] [strict-route]
or
[node](callout)#proxy before <index>
<host> [<port>] [strict-route]
or
[node](callout)#proxy after <index> <host>
[<port>] [strict-route]
Location Service configuration task list
Command
Command
Command
Command
Command
Purpose
Adds a new face to the identity. The no form of the
command removes an existing face with all content
in it.
Purpose
Adds or removes a profile to use if an outgoing
call destines this identity
Purpose
Selects which protocol to prefer if an outgoing call
destines this identity.
Purpose
Selects which traffic class to set if an outgoing call
destines this identity.
Purpose
Adds a new proxy entry to the call outbound face.
If the from-uri of a call originating from us matches
the identity for each proxy configured there is a
route-header added. If more than one proxy entry
has to be entered, the order of the list can be mod-
ified by using the index and/or the insert key-
words before and after.
51 • Location Service
611