Registration Outbound Face - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Registration outbound face

The registration outbound face is used to register an identity on an external registrar. Then, the registrar for-
wards calls from the registered identity to your identity.
Mode: Identity
Step
1 [node](identity)[name]# [no] registration
outbound
Mode: Registration outbound
Step
1 [node](regout)# [no] register [auto|none] Enables registration with auto or disables registra-
Mode: Registration outbound
Step
1 [node](regout)# [no] registrar <host>
[<port>]
Mode: Registration outbound
Step
1 [node](regout)# [no] lifetime <seconds>
Mode: Registration outbound
Step
1 [node](regout)# [no] retry-timeout (on-cli-
ent-error|on-sysstem-error|on-server-
error) <seconds>
Location Service configuration task list
Command
Command
Command
Command
Command
Purpose
Adds a new face to the identity. The no form of the
command removes an existing face with all content
in it.
Purpose
tion explicitly with none.
Purpose
Configures the address of the registrar to send
your register requests. When no registrar is config-
ured, the register requests are sent to the first
domain entry in the location-service.
Purpose
Configures the desired lifetime of the registration.
When no lifetime is configured the desired lifetime
is set to 3600 seconds.
Purpose
Configures the time to wait after a failed registra-
tion according to three different error categories.
After this time we begin to register from new. If no
retry-timeout is configured the retry-timeout is set to
10 seconds.
51 • Location Service
608