Call Inbound Face - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Call outbound
Step
1 [node](callout)#proxy <index> down <posi-
tions>
or
[node](callout)#proxy <index> up <posi-
tions>
Mode: Call outbound
Step
1 [node](callout)#no proxy [<index>]
Mode: Call outbound
Step
1 [node](callout)#proxy none

Call inbound face

The call inbound face is used to configure call properties for incoming calls.
Mode: Identity
Step
1 [node](identity)[name]# [no] call inbound Adds a new face to the identity. The no form of the
Mode: Call inbound
Step
1 [node](callin)[name]# [no] use profile
(sip|tone-set|voip) <profile>
Location Service configuration task list
Command
Command
Command
Command
Command
Purpose
If multiple proxies are configured the entry at the
index can be moved in the proxy list up or down
the number of positions given in the command.
Purpose
Removes the proxy entry at the index or remove all
proxy entries if no index is given.
Purpose
Removes all proxy entries and disables explicitly
the use of a proxy.
Purpose
command removes an existing face with all content
in it.
Purpose
Adds or removes a profile to use if an incoming
call destines this identity.
51 • Location Service
612