Configure The Sip Hold Method (Optional) - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Configure the SIP hold method (Optional)
There are different ways to set a remote SIP subscriber On Hold. This command specifies which method the
SmartNode uses to indicate this call state. In receive direction, all of them will be accepted.
Mode: Interface SIP
Step
1
[node](if-sip)[if-name]#hold-method
{direction-attribute | zero-ip}
SIP interface configuration task list
Command
39 • SIP interface configuration
Purpose
Configures the method to be used to signal
the hold state.
Default: zero-ip
450