Troubleshooting - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Troubleshooting

You can display basic status information of the H.323 gateway using the following command:
Mode: Configure
Step
1
node(gw-h323)[h323]# show gateway
h323 status [detail level]
Example: Display H.323 gateway status information
The following example shows how to display H.323 gateway status information and a sample output of the
command.
node(cfg)#show gateway h323 status
H.323 Gateway:
State:
Stack Handle:
RAS Engine
State:
Allocated Endpoints:
Allocated RAS Engines:
Allocated Control Channels:
Allocated Outgoing Logical Slowstart Channels: 0
Allocated Outgoing Logical Faststart Channels:0
Allocated Incoming Logical Channels:0
The H.323 gateway also provides several debugging monitors to observe its dynamic behavior. These monitors
allow efficient troubleshooting of H.323 problems. The most often used monitors are listed in the following
table.
Command to enable the monitor
node(cfg)#debug gateway h323 error
node(cfg)#debug gateway h323 tpktchan
node(cfg)#debug gateway h323 udpchan
node(cfg)#debug gateway h323 datapath
node(cfg)#debug gateway h323 signaling
Gateway configuration task list
Command
45 • H.323 gateway configuration
Displays H.323 gateway status information.
The detail level parameter is a number in the
range 0 to 5 and indicates how much detail
should be displayed.
h323
UP
0xb6a70c
UNREGISTERED
0
1
0
Output of the monitor
Logs all errors detected within the H.323 gateway
Logs all H.225 call signaling messages sent or received
over the IP network.
Logs all H.225 RAS messages sent or received over
the IP network
Logs information related to media channels
Logs call signaling related information
Purpose
553