Debugging Ppp - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Example: Display a PPP profile
node(pf-ppp)[PPPoE]#show profile ppp PPPoE
Profiles:
---------
Name:
LCP Configure-Request:
LCP Configure-Nak:
LCP Terminate-Request:
LCP Echo-Request:
MTU:
MRU:
Callback:
CHAP:
PAP:
Authentication:
IPCP Configure-Request:
IPCP Configure-Nak:
IPCP Terminate-Request:
Van-Jacobson Compression:
Van-Jacobson Decompression:allowed, max-slots 31
Name:
LCP Configure-Request:
LCP Configure-Nak:
LCP Terminate-Request:
LCP Echo-Request:
MTU:
MRU:
Callback:
CHAP:
PAP:
Authentication:
IPCP Configure-Request:
IPCP Configure-Nak:
IPCP Terminate-Request:
Van-Jacobson Compression:
Van-Jacobson Decompression:allowed, max-slots 31
Van-Jacobson Decompression:allowed, max-slots 31

Debugging PPP

A set of commands is available to check the status of the PPP connection and the PPPoE session. Furthermore,
two debug monitors help to analyze the dynamic behavior. The commands are listed in the order which you
should follow in case you encounter problems with PPP. This procedure describes how to display PPP configu-
ration information
PPP configuration task list
default
interval 3000 ms, max 10
max 5
interval 3000 ms, max 2
interval 10000 ms, max 3
68 - 1920
68 - 1920
both
allowed
allowed
interval 3000 ms, max 3
interval 3000 ms, max 10
max 5
interval 3000 ms, max 2
allowed, max-slots 31
PPPoE
interval 3000 ms, max 10
max 5
interval 3000 ms, max 2
interval 10000 ms, max 3
68 - 1492
68 - 1492
both
allowed
allowed
interval 3000 ms, max 3
interval 3000 ms, max 10
max 5
interval 3000 ms, max 2
allowed, max-slots 24
30 • PPP configuration
323