Displaying Rip Configuration Of An Ip Interface; Displaying Global Rip Information - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Displaying RIP configuration of an IP interface
Displaying the RIP configuration of an IP interface is useful to list the settings. This procedure describes how
to display the RIP configuration of an interface
Mode: Interface
Step
1 node(if-ip)[name]#show rip interface ifname Displays the RIP binding of an IP interface on
Example: Displaying RIP configuration of an IP interface
The following example shows how to display the RIP configuration of IP interface wan.
node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#show rip interface wan
Interface wan (IP context router):
--------------------------------------------------
send version: 1compatible
receive version: 1or2
learn host: disabled
learn default: disabled
announce host: disabled
announce static: disabled
announce default: disabled
announce self-as-default: disabled
route-holddown: enabled
poison-reverse: disabled
auto-summary: disabled
split-horizon: disabled
default-route-value: 0
--------------------------------------------------

Displaying global RIP information

SmartWare also support displaying global RIP information for the IP router context. This procedure describes
how to display the global RIP information
Mode: Configure
Step
1 node(cfg)#show rip
Example: Displaying global RIP information
The following example shows how to display the global RIP information.
node(cfg)#show rip
RIP information:
RIP configuration task list
Command
listen: disabled
supply: enabled
Command
Purpose
name
Purpose
Displays the RIP information
23 • RIP configuration
249