Patton electronics SmartNode Series Software Configuration Manual page 396

SmartWare Software Configuration Guide
The following procedure disables the reception of AOC messages from the network on an ISDN user interface.
Step
1
node(ctx-ip)[ctx-name]# interface isdn
<if-name>
2
node(if-isdn)[if-name]# no aoc-s
3
node(if-isdn)[if-name]# no aoc-d
4
node(if-isdn)[if-name]# no aoc-e
AOC is a network option that can be disable or set to be active for all calls or only on a per-call basis. If your
network provider offers AOC on a per-call basis the firmware needs to request AOC information on each out-
going call. The following procedure enables the reception of AOC messages on an ISDN user interface. Addi-
tionally the interface sends an AOC activation request for each outgoing call to the network.
Step
1
node(ctx-ip)[ctx-name]# interface isdn
<if-name>
2
node(if-isdn)[if-name]# aoc-s explicit
3
node(if-isdn)[if-name]# aoc-d explicit
4
node(if-isdn)[if-name]# aoc-e explicit
In default, an ISDN network interface provides AOC information to the connected phones only if available,
i.e. only if the call is routed to an ISDN user interface that is connected to a network providing AOC informa-
tion. The following procedure enables the transmission of AOC message on an ISDN network interface even if
ISDN interface configuration task list
Command
Command
34 • ISDN interface configuration
Purpose
Go to the ISDN interface, for which you want to
disable AOC
Disables the reception of AOC-S messages at call
setup time
Disables the reception of AOC-D messages during
the call
Disables the reception of AOC-E messages at the
end of the call
Purpose
Go to the ISDN interface, for which you want to
enable AOC on a per-call basis
Enables the reception of AOC-S messages and
sends an AOC-S activation request for each outgo-
ing call
Enables the reception of AOC-D messages and
sends an AOC-D activation request for each outgo-
ing call
Enables the reception of AOC-E messages and
sends an AOC-E activation request for each outgo-
ing call
396