Configure Partial Rerouting - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
node(if-isdn)[IF-LOCA~]#exit
node(ctx-cs)[switch]#interface h323 IF-NODE-B
node(if-h323)[IF-NODE-B]#route dest-interface IF-PBX-A
node(if-h323)[IF-NODE-B]#exit
node(ctx-cs)[switch]#interface sip IF-NODE-C
node(IF-NODE-C)[IF-NODE-C]#route dest-interface IF-PBX-A
node(IF-NODE-C)[IF-NODE-C]#exit
The configuration is now complete. Prior to activating the configuration enable the call router debug monitor
to check the loading of the call router elements.
node(cfg)#debug call-router
node(cfg)#context cs
node(ctx-cs)[switch]#no shutdown
02:14:30 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
node(ctx-cs)[switch]#
Configure partial rerouting
To save bandwidth and B-Channels, SmartWare supports partial rerouting. SmartWare accepts rerouting
requests from PBX, which want to push-back a diverted or forwarded call with a Rerouting Request. Smart-
Ware can generate such a reroute request to push-back a looped call. Both, acceptation and emission of rerout-
ing requests can be configured separately.
To prevent rerouting when a particular service is invoked in a call, services can be configured to allow or to for-
bid rerouting of calls of the service. In order that a call can be rerouted, all services participating in this call
must allow rerouting. In addition rerouting emit must be configured on the interface where this call comes in
and is routed out.
To accept or emit rerouting requests, see
To allow push-back, see
Call router configuration task list
> Updating tables in 3 seconds...
> [switch] Reloading tables now
> [switch] Flushing all tables
> [switch] Loading table 'TAB-ISDN-SERVICE'
> [switch] Loading table 'TAB-DEST-A'
> [switch] Loading table 'CAC-APPLE'
> [switch] Loading table 'CAC-ORANGE'
> [switch] Loading table 'CLI-MELON'
> [switch] Loading table 'MAP-CAC-APPLE'
> [switch] Loading table 'MAP-CAC-ORANGE'
> [switch] Loading table 'MAP-CLI-MELON'
> [switch] Loading table 'IF-LOCAL-BREAKOUT-precall-service'
> [switch] Loading table 'IF-PBX-A-precall-service'
> [switch] Loading table 'IF-NODE-B-precall-service'
> [switch] Loading table 'IF-NODE-C-precall-service'
"Call reroute"
"Allow Push-Back" on page 517.
40 • Call router configuration
on page 517.
516