Configuring The Traffic Class For Voice And Fax Data; Configuring Ip-Ip Codec Negotiation - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Configuring the traffic class for Voice and Fax data
The traffic class for voice data and fax data is configurable. The configured traffic class is used as additional
routing criterion in the IP routing table.
Mode: Profile VoIP
Step
1
[ name] (pf-voip)[profile]# rtp trafficclass
<traffic-class>
Configuring IP-IP codec negotiation
This command is only available on the SN4960 and applies to calls between two IP endpoints (e.g. SIP-SIP or
H.323-SIP). It is in mode "profile voip".
Step
1 node(pf-voip)[default]#[no] codec
negotiation
Disabled "codec negotiation" honors the codec lists from each call leg independently, formed out of the remote
and local capabilities. The DSP is inserted into the RTP path to make sure each side can use its codec. The
DSP is transcoding between the codecs of the two RTP streams.
Enabled "codec negotiation" will keep the DSP out of the picture for IP-IP calls and tries to negotiate a com-
mon codec for both call legs.
VoIP profile configuration task list
Command
Command
47 • VoIP profile configuration
Sets traffic class for voice data and fax data
packets. The traffic class may be new or may
already exist.
Purpose
Enables/disables codec negotiation.
Purpose
585