Call Reroute; Enable Acceptation Of Rerouting Requests On Isdn; Enable Emission Of Rerouting Requests On Isdn; Enable Sending Of "302 Moved Temporary" Message On Sip - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Call reroute

The call-reroute commands enable acceptation and emission of rerouting requests.
Enable acceptation of rerouting requests on ISDN. If a reroute is accepted, the participant who sends the
reroute request is disconnected and the call is established from the SmartNode to the new destination.
Mode: context cs/interface isdn
Step Command
1 [name](if-isdn)[interface]#[no] call-
reroute accept
Enable emission of rerouting requests on ISDN. To reroute a call must enter and leave SmartNode through
the same ISDN interface and every service invoked must allow push-back.
Mode: context cs/interface isdn
Step Command
1 [name](if-isdn)[interface]#[no] call-
reroute emit
Enable sending of "302 moved temporary" message on SIP. To reroute a call must enter and leave Smart-
Node through the same SIP gateway and every service invoked must allow push-back.
Mode: context cs/interface sip
Step Command
1 [name](if-sip)[interface]#[no] call-
reroute emit

Allow Push-Back

The push-back command allows or forbids rerouting of a call, if the service is invoked.
Enable push-back – aaa service.
Mode: context cs/service aaa
Step Command
1 [name](svc-aaa)[service]#[no]
allows-push-back
Call router configuration task list
Enables acceptation of rerouting requests from ISDN.
Default is disabled.
Enables emission of rerouting requests from ISDN.
Default is disabled.
Enables emission of "302 moved temporarily" message on
SIP. Default is disabled.
Enables push-back of a call of this service.
Default is disabled.
40 • Call router configuration
Purpose
Purpose
Purpose
Purpose
517