Deleting Mapping Tables - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
node(cfg)#context cs
node(ctx-cs)[switch]#mapping-table called-type-of-number to called-type-of-number
SET-INT
node(rt-tab)[SET-INT]#map default to international
Any called party number type matches the default entry. Note that the input-type of the table does not matter
when the mapping table contains only the default entry. Anyway an input-type must be specified when creat-
ing the mapping table.
The output (called party number type) is international.
The called party number type is set to international.
Example: Mapping table to replace called party numbers (translation table)
node(cfg)#context cs
node(ctx-cs)[switch]#mapping-table called-e164 to called-e164 TRANS
node(rt-tab)[TRANS]#map 550 to 250
node(rt-tab)[TRANS]#map 551 to 251
node(rt-tab)[TRANS]#map 552 to 252
node(rt-tab)[TRANS]#map 553 to 253
node(rt-tab)[TRANS]#map 554 to 254
node(rt-tab)[TRANS]#map 555 to 255
node(rt-tab)[TRANS]#map 556 to 256
node(rt-tab)[TRANS]#map 557 to 257
node(rt-tab)[TRANS]#map 558 to 258
node(rt-tab)[TRANS]#map 559 to 259
Note
The translation table above can be reduced using regular expressions.
node(cfg)#context cs
node(ctx-cs)[switch]#mapping-table called-e164 to called-e164 TRANS
node(rt-tab)[TRANS]#map 55(.) to 25\1

Deleting mapping tables

To remove individual mapping tables you can use the
you can remove specific entries of a mapping table by entering the mapping table configuration mode and use
the form of the
no map
Procedure: To delete an entry from a mapping table
Mode: Context CS
Step Command
node(ctx-cs)[switch]#mapping-table
1
table-name
node(map-tab)[table-name]#no map
2
key
3
Call router configuration task list
command.
form of the
no mapping table
Enter the mapping table from which you want to remove an
entry.
You do not have to enter the type of the table when
Note:
just entering it. The type must only be specified when creating
a table.
Remove the entry with the specified key.
Repeat Step 2 to remove additional entries.
40 • Call router configuration
command. Alternatively
Purpose
484