Using An Alternate Sip Profile (Optional); Using An Alternate Tone-Set Profile (Optional) - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Interface SIP
Step
1
[node](if-sip)[if-name]#use profile voip
profile-name
Using an alternate SIP profile (Optional)
The SIP profile contains a cause and reason mapping from SIP notation to the call control notation and vice
versa. The predefined default profile exists persistently in the system and it is preconfigured with proper default
mappings. It will always be taken if no other profile has been specified. This command allows the user to spec-
ify an alternate SIP profile to use for all calls routed over this interface. For details about SIP profile configura-
tion see Chapter 49, "SIP profile configuration"
When a profile has been specified on the interface, it is possible to provide a special one for specific identities or
group of identities. It can be configured in location service identities for call inbound and call outbound. See
Chapter 51, "Location Service"
identity lookup to find a possible configured SIP profile will always be applied to the remote SIP URI. For out-
going calls, the SIP Request-URI will be taken. For incoming calls, the SIP From-URI will be taken.
Mode: Interface SIP
Step
1
[node](if-sip)[if-name]#use profile sip pro-
file-name
Using an alternate Tone-Set profile (Optional)
A Tone-Set profile contains a mapping of call-progress tones to defined tone sequences. The predefined default
profile exists persistently in the system and it is preconfigured with the Swiss standard call-progress tone map-
ping. It will always be taken if no other profile has been specified. This command allows the user to specify an
alternate Tone-Set profile to be use for all calls routed over this interface. For details about Tone-Set profile
configuration see Chapter 42,
When a profile has been specified on the interface, it is possible to provide a special one for specific identities or
group of identities. It can be configured in location service identities for call inbound and call outbound. See
Chapter 51, "Location Service"
The identity lookup to find a possible configured Tone-Set profile will always be applied to the remote SIP
URI. For outgoing calls, the SIP Request-URI will be taken. For incoming calls, the SIP From-URI will be
taken.
SIP interface configuration task list
Command
on page 596.
on page 602 for details about identities and SIP profile configurations. The
Command
"Tone configuration" on page 524.
on page 602 for details about identites and Tone-Set profile configurations.
39 • SIP interface configuration
Purpose
Defines an alternate VoIP profile to be used
for this SIP interface.
Default: default
Purpose
Defines an alternate SIP profile to be used for
this SIP interface.
Default: default
440