Debugging Frame Relay - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
node(pvc)[1]#shutdown
Check the PVC 1 status by using
figuration part responsible for this PVC.
node(pvc)[1]#show running-config
Running configuration:
#----------------------------------------------------------------#
#
# 2500
...
pvc 1
encapsulation rfc1490
bind interface wan router
shutdown
exit
...

Debugging Frame Relay

A set of commands is available to check the status of the Framerelay connections, fragmentation process and
keepalive message exchange. Be aware that some monitors generate a lot of output and can seriously impact
your system performance.This procedure describes how to display the Frame Relay configuration settings for
the serial interface
Mode: Administrator execution
[no] debug framerelay
[no] debug framerelay all
[no] debug framerelay error
[no] debug framerelay lmi
[no] debug framerelay management
[no] debug framerelay packets
Frame Relay configuration task list
show running-config
Command
15 • Frame Relay configuration
and verify that the entry shutdown occurs in the con-
Purpose
Prints the status of the different monitors (ON or
OFF)
Enables/Disables all framerelay debug monitors
Enables/Disables monitor which prints only
occurred errors.
Enables/Disables monitor which prints keepalive
events and messages
Enables/Disables monitor which prints management
and configuration events
Enables/Disables monitor which prints dlci, size and
fragmentation status of every incoming and outgo-
ing packet. Be aware that this monitor can seriously
impact your system performance.
#
#
183