Dial-Up On Monitor; Dial-Up Nailed - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Dial-up on monitor

Dial when a monitored interface is reported down and drop when that interface is reported up again. A delay
time prevents to dial or drop if the monitored interface changes the state only for a short time.
Mode: context ip/interface
Step Command
1 [name] (if-ip) [interface]#[no] dial-up mon-
itor interface <ip-interface> [dial delay
<seconds>] [drop delay <seconds>]
[queue-limit <number>]

Dial-up nailed

Dial if possible, and never drop.
Mode: context ip/interface
Step Command
1 [name] (if-ip) [interface]#[no] dial-up
nailed [queue-limit <number>]
PPP Dial-up over ISDN
30 • PPP configuration
Purpose
Configure dial-up to monitor the interface
specified. Dial delay specifies the timeout
before dialing (Default 10). Drop delay speci-
fies the timeout before dropping connection
(Default 10). Queue-limit specifies the max.
number of packets to queue while the link is
down (Default 4).
Purpose
Configure dial-up nailed. Queue-limit speci-
fies the max. number of packets to queue
while the link is down (Default 4).
336