Test The Call Router Configuration - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Procedure: To show and activate the call router configuration
Mode: Context CS
Step Command
node(ctx-cs)[switch]#show call-router
1
config
node(ctx-cs)[switch]#show running-
2
config
node(ctx-cs)[switch]#debug call-
3
router detail level
4 node(ctx-cs)[switch]#no shutdown
node(ctx-cs)[switch]#show call-router
5
status
Note
Unlike previous versions of SmartWare you must explicitly enter the
shutdown
Test the call router configuration
After activating the call router configuration you can test the call router by simulating a route lookup as if a call
is routed to a table. You have to execute the test call-router command and specify all necessary call properties
together with the routing table you want to test.
Note
You must activate the call router using the
Procedure: To test the call router configuration
Mode: Context CS
Step Command
node(ctx-cs)[switch]#debug call-
1
router detail level
2 node(ctx-cs)[switch]#test call-router
table-name [property-type property-
value]
Example: Create and test a routing table
node(cfg)#context cs
node(cts-cs)[switch]#routing-table called-e164 TEST
node(rt-tab)[TEST]#route 1 dest-interface IF1
node(rt-tab)[TEST]#route 1[0-4] dest-interface IF2
node(rt-tab)[TEST]#route 11 dest-interface IF3
node(rt-tab)[TEST]#route 111T dest-interface IF4
Call router configuration task list
Show the actual call router configuration. This displays all
routing and mapping tables in the current context CS. When
you are inside a routing or mapping table configuration
mode, only the current table is displayed.
Show the whole running config includes the call routing
tables
Enable the call router debug monitor. Use level 1 for get
informed about errors and increase the level up to 5 to track
calls during route lookups.
Activate the whole CS context configuration including the call
router configuration.
Show the actual call router status. This command can be used
to examine whether or not the call router accepted all routing
entries as entered in the configuration.
command to activate the call router.
Enables the call router debug monitor. Chose level 5 to trace
route lookups in detail.
Tests the routing or mapping table table-name with the speci-
fied call property. You can repeat the optional section multi-
ple times and thus enter as many call properties as you want.
40 • Call router configuration
Purpose
command first.
no shutdown
Purpose
no
510