Structure - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Structure

This guide contains the following chapters and appendices:
• Chapter 1, "System overview"
• Chapter 2, "Configuration concepts"
• Chapter 3, "Command line interface (CLI)"
that allow you to navigate the CLI and edit commands effectively.
• Chapter 4, "Accessing the CLI"
the command line interface (CLI), to obtain help, to change operator mode and to terminate a session.
• Chapter 5, "System image handling"
driver software.
• Chapter 6, "Configuration file handling"
files from and to a SmartNode.
• Chapter 7, "Basic system management"
tion to the operator or administrator, and their configuration.
• Chapter 8, "RADIUS Client Configuration"
authorization, and accounting (AAA) component in SmartWare and describes how to configure the
RADIUS client, a subpart of the AAA component.
• Chapter 9, "IP context overview"
with its related components.
• Chapter 10, "IP interface configuration"
and describes the tasks involved in their configuration.
• Chapter 11, "NAT/NAPT configuration"
port translation and describes the tasks involved in its configuration.
• Chapter 12, "Ethernet port configuration"
describes the tasks involved in their configuration through SmartWare.
• Chapter 13, "Link scheduler configuration"
quality of service (QoS) features.
• Chapter 14, "Serial port configuration"
the tasks involved in its configuration through SmartWare.
• Chapter 15, "Frame Relay configuration"
through SmartWare.
• Chapter 16, "PRI port configuration"
teristics and the tasks involved in the configuration.
• Chapter 17, "BRI port configuration"
ports, their characteristics and the tasks involved in the configuration.
• Chapter 18, "ISDN Overview"
involved in configuring ISDN ports in SmartWare.
on page 38 provides an overview of the main elements of a SmartWare system.
on page 44 introduces basic SmartWare configuration concepts.
on page 49 gives an overview of the CLI and the basic features
on page 53 describes the procedures for entering SmartWare commands via
on page 64 describes how to load and maintain system images and
on page 75 describes how to upload and download configuration
on page 89 describes parameters that report basic system informa-
on page 101 provides an overview of the authentication,
on page 112 outlines SmartWare Internet protocol (IP) context, together
on page 118 provides a general overview of SmartNode interfaces
on page 130 provides a general overview of the network address
on page 139 provides an overview of Ethernet ports and
on page 149 describes how to use and configure SmartWare
on page 168 provides an overview of the serial port and describes
on page 175 provides an overview of how to configure frame relay
on page 189 provides an overview of the T1/E1 ports, their charac-
on page 203 provides an overview of the BRI (Basic Rate Interface)
on page 210 provides an overview of ISDN ports and describes the tasks
About this guide
31