Egress Interface - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
not the egress interface propagates the address-complete indication depends on the interface configuration
(see below).
The next table shows the different digit-collection terminating-character configurations and their effect on a T-
terminated route when the terminating-character is received.
Digit Collection Terminating-Char
Configuration
Terminating- append-
Char terminating-
char
No no
yes
Yes no
yes
The command digit-collection full-match has been introduced. The syntax is:
digit-collection full-match [append-terminating-char] [set-address-complete-indication]
This command configures what action(s) shall be performed when a dollar-($)-terminated rule is selected in a
called-e164 routing-table. We call such an entry a fully specified number entry. The append-terminating-char
action appends the terminating-character; while the set-address-complete-indication action sets the address-
complete indication. Whether or not the egress interface propagates the address-complete indication depends
on the interface configuration (see below).

Egress Interface

On the egress interface (ISDN, H.323) the address-complete-indication emit <type> command configures
how the internal representation of the address-complete indication shall be mapped to the representation of the
signaling-protocol.
Call router configuration task list
Ingress Properties
set- called-e164
address-
complete-
indication
no 123#
yes
no
yes
no
yes
no
yes
40 • Call router configuration
Egress Properties
(Result of call-routing)
Address- called-e164
Complete
Indication
False 123#
true
false
true
false
true
false
true
false 123
true
false
true
false 123#
true
false
true
Address-
Complete
Indication
false
true
false
true
false
true
false
true
false
true
true
true
false
true
true
true
490