Call Waiting Reminder Ring; Drop Passive Call; Drop Active Call; Call Toggle - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Call waiting reminder ring

If a remote subscriber disconnects the call, the local subscriber will hear the release tone and go on-hook. But,
if there is still a pending remote subscriber that has been previously set on hold, the phone rings right after on-
hook. If the local subscriber goes off-hook, the user will be connected again with the previously held remote
subscriber. It is possible to navigate to the pending held subscriber. As soon as the release tone appears, the local
subscriber can touch flash to connect again.

Drop passive call

If the local subscriber hears the call waiting tone that indicates a second incoming call and decides not to dis-
turb the current one, the drop passive call feature rejects the waiting call. It can also be used to drop a pending
call that has been previously set on hold.

Drop active call

The drop active call service can be used if the local subscriber has an active call and a call previously set on
hold. This feature provides the possibility to drop the active call and to switch to the hold one without going
on-hook first.

Call toggle

In general, the call toggle feature is used to switch between an active and a passive call. The passive call can
either be a call previously set on hold or a waiting call.

Call transfer

The call transfer feature is only available if the second call was originated by the local subscriber. For execution,
the local subscriber goes on-hook and the active call and the held call will be transferred together. If the second
call was an incoming call, the active call will be dropped and the CWRR will appear to signal a pending hold
call. It is possible to disable this service by executing the command no call-transfer on the fxs interface.
Mode: Interface FXS
Step
1
[name](if-fxs)[name]#[no] call-transfer
FXS supplementary services description
Command
35 • FXS interface configuration
Purpose
Enables or disables the call transfer feature.
Default: enabled
407