Smartnode In An Enterprise Network - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
02:14:30 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
02:14:33 CR
node(ctx-cs)[switch]#
Example: Configure SmartNode in an Enterprise Network
Situation: Figure 50 shows an enterprise network with a SmartNode configured with a BRI port. A PBX, a
LAN, the PSTN, and the company network are connected. The VoIP protocol used is H.323. There is no gate-
keeper, so direct call signaling is used. The voice codec used is G.723, so the DTMF relay is enabled. Because
no special dial tones have to be specified, the default tone-set profile is used.
Office A
Office B
Call routing is specified as follows:
• Calls from office C with number 1xx to office A with a fallback to PSTN
• Calls from office C with number 2xx to office B with a fallback to PSTN
• All other calls from office C to PSTN
Activating CS context configuration
> Updating tables in 3 seconds...
> [switch] Reloading tables now
> [switch] Flushing all tables
> [switch] Loading table 'TAB-ISDN-SERVICE'
> [switch] Loading table 'TAB-DEST-A'
> [switch] Loading table 'CAC-APPLE'
> [switch] Loading table 'CAC-ORANGE'
> [switch] Loading table 'CLI-MELON'
> [switch] Loading table 'MAP-CAC-APPLE'
> [switch] Loading table 'MAP-CAC-ORANGE'
> [switch] Loading table 'MAP-CLI-MELON'
> [switch] Loading table 'IF-LOCAL-BA-precall-service'
> [switch] Loading table 'IF-PBX-A-precall-service'
> [switch] Loading table 'IF-NODE-B-precall-service'
> [switch] Loading table 'IF-NODE-C-precall-service'
PSTN
147.86.130.11
Company
Backbone
147.86.130.24
Figure 50. SmartNode in an Enterprise network
clock distribution
Office C
PBX
User User
2/3 2/2
Net
2/1
Node
Net
147.86.130.1
2/0
31 • CS context overview
349