Displaying Reports; Controlling Command Execution - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
System resets may have a number of reasons, the most prominent being a manual reset issued on the Telnet/
console ('reload'). Other reset reasons include power off failures and system failures. In order to pinpoint the
problem, the reset log contains the reset cause.
Mode: Administrator execution
Step Command
1 node#show log [event]
2 node#show log supervisor Show log of the system supervisor. Used For example, after an unex-
3 node#show log reset
4 node#show log boot
5 node#show log login
6 node#show log file-
transfer

Displaying reports

The show reports command is used to dump combined system information. The show reports command
sequentially executes the following log commands:
show version
show clock
show uptime
show licenses
show memory stat
show log reset
show log boot
show log event
show log supervisor
show factory-config
show startup-config
show running-config
Mode: Administrator execution
Step Command
1 node#show reports

Controlling command execution

The SmartWare command shell includes a basic set of commands that allow you to control the execution of
other running commands. In SmartWare, the commands
mand jobs lists all running commands, and
ground. Moreover using <ctrl>-<z> suspends an active command and lets the system prompt reappear. With
<ctrl>-<c> the currently active command can be terminated.
Basic system management configuration task list
Show event log.
pectedly reboot.
Output a list of reset reasons (with date and time).
Displays the console and log messages captured during startup of the
unit.
Displays a list of succeeded and failed CLI login attempts.
Displays the history of all recently executed file transfer operations
(up to 50 entries).
Dumps the combined system information.
and
jobs
fg allows switching back a suspended command to the fore-
7 • Basic system management
Purpose
Purpose
are used for such purposes. The com-
fg
97