Configure Codecs - Patton electronics SmartNode Series Software Configuration Manual

Software for smartnode series

Hide thumbs Also See for SmartNode Series:

Table of Contents

SmartWare Software Configuration Guide

Conﬁgure codecs

The VoIP proﬁle contains a list of codecs the forms the set of allowed codecs that can be used to set up a VoIP

connection. The list is assembled in order of priority (i.e. the ﬁrst entered codec is the most preferred one). For

each codec in the list, a set of parameters can be conﬁgured.

Procedure: Add a codec to the list (this procedure is valid for all other codecs as well).

If you press the <tab> key after entering a few letters of a conﬁguration com-

mand, the full command name will display or a listing of commands that

begin with those letters will display. Press the <enter> key to select the

desired command.

VoIP profile configuration task list

Signaling protocols have a codec negotiation mechanism, it is not

guaranteed that the ﬁrst codec in the list is used to set up the con-

nection. Each codec in the list may be used. To make sure that

only one codec is possible, conﬁgure this codec alone. See how

to display the currently conﬁgured codecs in a VoIP proﬁle on

The default VoIP proﬁle contains the codecs G.711uLaw and

G.711aLaw. If you don't want to use these, you must explicitly

remove them from the list.

47 • VoIP profile configuration

Troubleshooting

Smartware release 5.1