Introduction - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Introduction

This chapter gives an overview of the circuit-switching (CS) context and associated components, and describes
the tasks involved in its configuration. It describes the steps needed configure voice connectivity, and refers to
other chapters where a configuration topic is explained in more detail. Before reviewing the content in this
chapter, read the configuration concepts as described in chapter 2,
The CS context is a high level conceptual entity that is responsible for all aspects of circuit signaling, switching,
and emulation. Besides the CS context itself, the CS entity consists of the following (indicated by the shaded
area enclosed by a dashed line in
• The CS interfaces
• ISDN and FXS ports
• Tone-set profiles
• SIP and H.323 gateways
• VoIP profiles
The CS Context is enabled by default.
Gateway
NAPT
Profile
Context
use command
ACL
Interfaces
Profile
bind command
Circuit
Ports

Introduction

figure 47):
bind command
QoS
Context
Profile
IP
router
use command
bind command
Figure 47. CS context configuration components
"Configuration concepts"
use commands
H.323 GW
bind commands
SIP GW
VoIP
Profile
use
commands
Tone-set
Profile
Tone-set
Profile
bind command
31 • CS context overview
on page 44.
VoIP
Profile
use
commands
Tone-set
Context
Profile
CS
switch
Tone-set
Profile
bind command
338