SmartWare Software Configuration Guide
1. From-URI-Host equal Remote
and
Request-URI-Host equal Local
2. From-URI-Host equal Remote
3. Request-URI-Host equal Local
4. No match, the first configured will be taken
For detailed information about call control SIP interface configuration, see Chapter 39,
uration"
on page 436.
Context SIP Gateway configuration task list
The following section describes how to create a new context SIP gateway and how to enter the configuration
mode of an existing context SIP gateway. Additionally, it describes all commands and sub commands of the
context SIP gateway configuration mode. All configuration tasks for a Context SIP Gateway are listed below.
•
Create a context SIP gateway (see
•
Create a transport interface (see
•
Configure the IP binding (see
•
Configure a priority (see
•
Configure a spoofed contact address (see
•
Bind location services (see
•
Enable/Disable (see
Creating a context SIP gateway
The context sip-gateway command enters the configuration mode of a context SIP gateway. If the requested
one does not exist, a new one will be created. The no form of the command removes an existing context SIP
gateway. This command can be entered without specifying a name. In this case, the default name sip will be
taken.
Mode: Configure
Step
1
[node](cfg)# [no] context sip-gateway
[<name>]
Context SIP Gateway configuration task list
page
556)
page
557)
page
557)
page
557)
page
page
558)
page
558)
Command
46 • Context SIP gateway overview
558)
Creates/Destroys a context SIP gateway or
enter configuration mode.
"SIP interface config-
Purpose
556