Fxs Port Configuration; Introduction; Shutdown And Enable Fxs Ports - Patton electronics SmartNode Series Software Configuration Manual

Software for smartnode series
Hide thumbs Also See for SmartNode Series:
Table of Contents

Advertisement

SmartWare Software Configuration Guide

Introduction

This chapter provides an overview of POTS signaling and SmartNode FXS ports and describes the tasks
involved in configuring FXS ports in SmartWare.
This chapter includes the following sections:
Shutdown and enable FXS ports (see
Bind FXS ports to higher layer protocols (see
Configure country specific FXS port parameters (see
Configure other FXS port parameters (see
Select a low-bit-rate codec for FXS ports
Example
FXS stands for foreign exchange station and is the exchange side of a POTS (plain old telephone system) line. Even
though POTS is seen as old technology it still plays an important part in today's telecommunications networks.
There are still a large number of analog phone sets in use worldwide and will do so in the future. These analog
devices, be they phones, facsimile machines and the like, represent a large investment and it is desirable to have
the technical means to hook such devices to a Voice over IP enabled network. POTS signaling.
The signaling procedure used on FXS ports is different throughout different countries, but the basic idea is to
use the POTS line itself as a current loop which signals off-hook and on-hook of the handset. Going off-hook
establishes a connection between the phone and whatever is on the other side (CO switch, SmartNode, etc.).

Shutdown and enable FXS ports

FXS ports are enabled by default. They also can be configured when they are active. But keep in mind that con-
figuration of an active port temporarily disables the port for a short time (some milliseconds).
Mode: Context CS
Step
Command
1
(config)#port fxs slot port
2
(prt-fxs)[slot/port]#shut-
down
3
(prt-fxs) [slot/port]#no shut-
down
Introduction
page
533)
page
535)
page
534)
page
535)
Enter FXS port configuration mode
Shutdown the port. All active calls are dropped!
Activate the port.
43 • FXS port configuration
Purpose
533

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartware release 5.1

Table of Contents