Enabling And Disabling The Sntp Client; Defining Sntp Client Poll Interval - Patton electronics SmartNode Series Software Configuration Manual

Software for smartnode series

Hide thumbs Also See for SmartNode Series:

Table of Contents

SmartWare Software Configuration Guide

Enabling and disabling the SNTP client

The SNTP client is disabled by default and has to be enabled if clock synchronization shall be used. This pro-

cedure describes how to enable or disable the SNTP client

Mode: Conﬁgure

node(cfg)#[no] sntp-client Enables the SNTP client operation. Using the no command syntax dis-

Example: Enabling the SNTP client operation

node(cfg)#sntp-client

Example: Disabling the SNTP client operation

node(cfg)#no sntp-client

Deﬁning SNTP client poll interval

Speciﬁes the seconds between each SNTP client request in unicast or anycast mode.

This SNTP client poll interval can be deﬁned to be within the range from 1 to 4'294'967'295. The default

value is 60 seconds.

This procedure describes how to set the SNTP client poll interval

Mode: Conﬁgure

node(cfg)#sntp-client poll-interval value Sets the SNTP client poll interval to value seconds

Example: Setting the SNTP client poll interval

In the following example the SNTP client poll interval is set to 30 seconds.

node(cfg)#sntp-client poll-interval 30

SNTP client configuration task list

ables this feature.

26 • SNTP client configuration

Smartware release 5.1