Patton electronics SmartNode Series Software Configuration Manual page 100

SmartWare Software Configuration Guide
Step
2 [name] (sys)#[no] terminal idle-time-
logout
3 [name] (sys)#terminal more
4 [name] (sys)#terminal width
When there are many VoIP units in the same location, use this command to flash all the LED's on a specific
unit for a specified period of time. This makes identification of the physical unit very easy.
Step
1 [name] #blink <seconds>
Basic system management configuration task list
Command
Command
7 • Basic system management
Purpose
After 30 minutes without user input, a terminal session
is automatically closed. If longer session periods are
required (logging/debugging) this command allows
to increase the session timeout, or to disable it com-
pletely.
Enables pausing of display for commands which pro-
duce more output than the current terminal window
can display at once.
Configures the terminal width.
Purpose
Enter an integer for the period of time you want the
LED's to flash on the physical unit.
100