Wildcard Symbols Used As Keys In E.164 Tables (Calling-E164, Called-E164) - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
The following table shows the wildcard characters that are supported:
Table 18. Wildcard symbols used as keys in E.164 tables (calling-e164, called-e164)
Symbol
. Indicates a single-digit placeholder. For example, 888 . . . . matches any dialed number beginning
with 888, plus at least four additional digits. Note that the key only specifies the prefix. Thus the num-
ber may be longer, but also matches.
[ ] Indicates a range of digits. A consecutive range is indicated with a hyphen (-); e.g. [5-7]. A noncon-
secutive range is indicated without a delimiter. For example, [58]. Both can be used in combination;
e.g. [5-79], which is the same as [5679]. A (^) symbol may be placed right after the opening bracket
to indicate that the specified range is an exclude list. For example, [^01] specifies the same range as
[2-9].
Only single-digit ranges are supported. You cannot specify the range of numbers between 99
Note:
and 102 using [99-102].
( ) Indicates a pattern. For example, 888(2525). It is used in conjunction with the symbol (?), (%) or (+)
or when replacing a number in a mapping table.
? Indicates that the preceding digit or pattern occurred zero or one time. Enter Ctrl-V before entering
(?) from your keyboard, since the CLI normally uses the question mark to display help texts.
% Indicates that the preceding digit or pattern occurred zero or more times. This functions the same as
the asterisk (*) used in regular expression. Here the percent (%) symbol is used to be able to handle
the asterisk (*) as part of a dialed number.
+ Indicates that the preceding digit or pattern occurred one or more times.
T Enables digit-collection for this entry. The call router pauses to collect additional dialed digits. The
default digit collection timeout is 5 seconds. The collection can be aborted pressing the pound (#)
key.
Note: The terminating character is used only to terminate the timeout and is therefore removed from
the dialed number.
The timeout (T) symbol is only allowed for Called Party Number table entries, while all other
Note:
wildcards are also allowed for Calling Party Number tables.
Call router configuration task list
Description
40 • Call router configuration
462