H.323 Interface Configuration Task List; Binding The Interface To An H.323 Gateway - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
• Configuring information transfer capability handling (optional)
• Configuring CLIP/CLIR support (optional)
• Enabling the early-proceeding feature for call setup
• Enabling the early call disconnect (optional)
• Enabling the via address support (optional)
• Overriding the default destination call-signaling port (optional)
• Configuring status inquiry settings (optional)

Binding the interface to an H.323 gateway

Every H.323 interface must be explicitly bound to an H.323 gateway instance.
Procedure: To bind an H.323 interface to an H.323 gateway.
Mode: Interface H.323
Step
1
node(if-h323)[if-name]#bind gateway
gw-name
Examples: Bind the H.323 interfaces to an H.323 gateway instance
The following example shows how to bind an H.323 interface named MyH323If to an H.323 gateway instance
named h323.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#bind gateway h323
Configure a remote IP address
If the gateway to which the H.323 interface is bound does not use a gatekeeper, it is required to specify the IP
address of the remote entity for which the H.323 interface is used directly within the H.323 interface. This is
done using the procedure below. If the H.323 gateway however uses a gatekeeper, the gatekeeper is responsible
for resolving the remote entities IP address. In that case this procedure must not be used.
Procedure: To specify the remote H.323 entities IP address in the H.323 interface.
Mode: Interface H.323
Step
1
node(if-h323)[if-name]#remoteip ip-
address
Examples: Define the IP address of the remote H.323 entity

H.323 interface configuration task list

Command
Command
38 • H.323 interface configuration
Purpose
Binds the gateway to an H.323 gateway.
Purpose
Defines the IP address of the remote H.323
entity, for which this interface shall be used.
428