Patton electronics SmartNode Series Software Configuration Manual page 572

SmartWare Software Configuration Guide
Mode: Profile VoIP
Step
1 node(pf-voip)[name]#codec g729 tx-
length 30 rx-length 30 silence-
suppression
a. Cisco does not use the standard ITU G.726 version of G.726, but the ATM AAL2 version. This build series now supports both versions of these codecs. The Cisco
G.726 codecs are available in profile voip as separate codecs with their name ending in -cisco.
Procedure: Remove a codec from the list
Mode: Profile VoIP
Step
1 node(pf-voip)[name]#no codec g729
Procedure: Insert a codec at a specific position in the list
VoIP profile configuration task list
Command
Command
47 • VoIP profile configuration
Purpose
Appends codec g729 to the list of codecs. Speci-
fies the payload duration for transmitted RTP pack-
ets of this codec, and the maximum supported
payload duration for received RTP packets of this
codec. Allows silence suppression to be used with
this codec.
If the codec g729 already existed in the list, its
parameters are updated with the entered values.
The following codecs are available:
g711alaw64k
•
• g711ulaw64k
g723-5k3
•
• g723-6k3
g726-16k
•
a
g726-16k-cisco
•
• g726-24k
g726-24k-cisco
•
• g726-32k
g726-32k-cisco
•
• g726-40k
g727-16k
•
• g727-24k
g727-32k
•
g729
•
netcoder-6k4
•
netcoder-9k6
•
transparent
•
transparent-cisco
•
Purpose
Remove codec g729 from the list of codecs.
572